International VC17M Antifouling Graphite 2L

International VC17m antifouling paint creates an incredibly smooth surface even without sanding. Its low friction finish can then be burnished to create an even smoother finish. International VC17m antifouling paint dries in 20 minutes to a very smooth, low friction surface, doesn't create a build up of paint and is suitable for burnishing to provide a smoother finish. It is a hard antifouling for boat hulls (below the waterline), suitable for: sea water, fresh water and brackish water. Typical Shelf Life: 2 Years. Do not brush apply. This is a flammable liquid and vapor and can cause skin and eye irritation.

Preparation:

o OLD VC: 17m Wash down with fresh water.

o OTHER ANTIFOULINGS: Use Interstrip to remove all traces of antifouling.

o BARE GRP: Use VC General Thinner to clean and fully degrease the surface. Lightly sand with 240 grade paper. Rinse with fresh water and allow to dry. Use VC Tar2 to prime and protect against osmosis.

o STEEL: Prime with VC Tar2 to prevent corrosion.

o LEAD: Prime with VC Tar2.

o WOOD: Consult your International Paint Representative for specific recommendations.

Mixing: Cut a small corner of the plastic bag containing the powder (stored under the plastic hat) and carefully pour the powder into the can. This should be done indoor or shield from wind and ensuring the powder is poured as closely to the surface as possible to avoid any waste of the powder into the environment. Stir or shake thoroughly for 5 minuts to ensure homogeneity of the paint. The can is large enough to allow easy stirring. Once mixed the product can be used for up to 7 days, provided it is stored with the lid on and mixed thoroughly for 5 minutes before application.

Thinning: Thinning is not recommended. Antifouling performance can be compromised if correct dry film thickness is not applied.

Cleaner: YTA600 VC General Thinner. VC General Thinner can be used to remove splashes of VC 17m from the topsides.